Adafruit Flex Cable for Raspberry Pi Camera - 24\" / 610mm

Product Specifications

• Adafruit Part Number: 1731
• Stock Type: Raspberry Pi >> Cables >> Camera

• In Stock & Ready to Ship

  Product Description

This cable will let you swap out the stock 150mm long flex cable from a Raspberry Pi Camera (either ‘classic’ or ‘NoIR’ type) for a different size. Works great, just carefully open the connector on the Pi and slip this one in.

This cable is 24” / 610mm long We have cables in 2”, 4”, 8”, 12”, and 18” long so you can have the perfect fit. Each order comes with one cable, Pi Camera not included (but we have those in the shop as well).

Product Reviews

Pi no longer precariously perched upon my printer

Fantastic. This cable fit my needs perfectly. It also seems to be of the same or better quality as the cable that came with my Pi camera. I had previously mounted the RasPi camera inside my 3D printer (check out OctoPi for a good place to start) and the original Pi camera cable was way too short. This new longer cable enabled me to finally mount the Pi board under the printer and run this ribbon cable up into the enclosure to the camera instead of leaving my Pi precariously perched upon my printer.READ MORE

Works fine.

Bought this cable to mount the camera in a better position without having to mount the RPi close by. Now the RPi sits behind a monitor on the desk and the camera sits higher with a nicely concealed vantage point and emails me a picture any time someone goes near my desk.READ MORE

I was pleased with it

The Cable worked well for the short period that I used it. It was not long enough to reach from the Raspberry Pi in the base to the camera mounted on the top of my 3D printer. Other than being too short, I was pleased with it.READ MORE

Long rPi camera cable, works great!

Great cable for your rPi camera module. I needed a long one for my current project and this was perfect.READ MORE

Works just as you would expect

Cant go too wrong with this product. It allows you to clamp in the cable and get a better reach on the camera. Tried it out and no issue it all.READ MORE

It works!

It is what it says it is. Works great to move camera further from your Pi. Just a quick note for those that may not know what they are looking at, this is a replacement for the existing cable, NOT an extension, meaning you can’t plug the two together to make a even longer cable.READ MORE

good cable

it is a cable nicely made and fits works fine longer then I needed it to be but better then too short.READ MORE

I needed a little longer ribbon for my camera. …

I needed a little longer ribbon for my camera. This worked out perfectly. My raspberry pi is inside and my camera sits outside (in a housing). This ribbon allowed me plenty of slack in the set up I createdREAD MORE

Perfect addition for the Raspberry Pi

This is the perfect length for the camera module. Now I can set up the camera so I don’t have to use the vertical and horizontal flip options.

No issues with this at all. I’ve been using …

No issues with this at all. I’ve been using it to connect to a picam bolted to my 3d printers bed. So the cable sees a lot of movement.

Four Stars

it does what it design for

Gets the job done

Works as expected!

Five Stars

works as advertised

Fantastic!

Used it for my 3d printer setup works better than the original

It works!

Works! Thank you!

You need this

Great and necessary accessory for your RPi Camera board.

Five Stars

Works well, no issues with my Raspberry Pi B.

Keep it as short as you can.

There is some signal loss from longer cables, but if you need it this works.

Get it at Amazon

comments powered by Disqus