McIgIcM 5pcs Micro USB 5V 1A 18650 TP4056 Lithium Battery Charger Module Charging Board With Protection Dual Functions 1A Li-ion
by people ...
Product Specifications
- Micro usb lithium battery charging board with overcharge, overdischarge and overcurrent protection
- On-board micro USB and soldering joints 5V input`port and charging status indicator(red indicator is charging,green indicator is full charged)
- Input Voltage: DC5V,Charging Cut-off Voltage: 4.2V Maximum Charging Current: 1A
Current: 3A, Board Size: 26 X 17mm/1.02 X 0.67inch(L*W)
Product Description
- MINI USB input terminal with a female, can be directly input to do with the phone charger rechargeable lithium battery, And still retains the input voltage wiring pads, can be very convenient DIY.
- It can be used for voltage 3.6 3.7V, etc. 18650, polymer and other lithium battery charge and discharge protection.
- Input voltage: 5V
- Charging cut-off voltage: 4.2V
- Maximum charge current: 1000mA
- Battery over-discharge protection voltage: 2.5V
- Battery overcurrent protection current: 3A
- Board size : 17.16 mm x 26.17 mm
Product Reviews
Good product, one dead unit.
These are great little charge boards, but I had to take a star off due to having one that is defective. For the price I kinda thought there may be one that isn’t good. This really shouldn’t happen though, they should all be good, but when something is cheap, well you know, no quality control.
Actually provides over discharge protection for batteries. Does NOT …
Actually provides over discharge protection for batteries. Does NOT boot convert to 5v. The power output is whatever the battery voltage is. DO NOT attempt to charge with a load on it. It will not go through proper charge stages and could damage batteries.
Five Stars
They work fine. Pretty neat .
Five Stars
Great value!
Work well
All 5 arrived in good condition and work as described.
Four Stars
good
Five Stars
great!
Five Stars
Great product.
Work well, but may need better separation of input pads.
These work very well. However, the positive input pad is very close to the ground traces, and one of these actually arced over during use.
But these are basically garbage for me unless I can figure out which resistor …
comments powered by DisqusThe cutoff voltage on the boards I got is about 2.4v, which is far too low for an 18650 cell. And there were crooked components on about 1⁄3 of the 15 boards I got.
