Raspberry Pi Camera Case / Enclouser - Black assemble in 30 secs
by people ...
Product Specifications
- This is a no-nonsense protective case designed specifically for the Raspberry Pi Camera
- The case is a two-piece injection-moulded ABS enclosure that snaps together around the Raspberry Pi Camera. Holds the Raspberry Pi Camera firmly in place.
- It provides tough protection for the Raspberry Pi Camera
- Wall Mountable (Screws and double tape included)
Raspberry pi Camera not included- Case only
Product Description
This is an elegant and innovative protective case designed specifically for the Raspberry Pi Camera. The case is a two-piece injection-moulded ABS enclosure that snaps together around the Raspberry Pi Camera. It provides tough protection for the Raspberry Pi Camera while providing access to connectors.
Product Reviews
Doesn’t fit piCamera 2. Camera works when out of …
Doesn’t fit piCamera 2. Camera works when out of the case, doesn’t work when in the case! The camera doesn’t fit into the aperture in the front of the case very well. The plastic piece that holds the camera in place when the case is locked somehow puts too much pressure on the circuit board – you’ll get “Out of Memory” errors in Python when trying to run a program that uses the camera (when it is in the case).READ MORE
It’s a little stubborn.
Had a little issue with the way the camera fit into the case but I finally got it.READ MORE
Three Stars
The housing doeosn’t clip together too securely, but it does the jb for which it is intendedREAD MORE
camera doesn’t fit inside
Poorly made.Camera doesn’t fit inside properly.READ MORE
The lens seems a little off center, it’s just …
The lens seems a little off center, it’s just made of plastic, nothing remarkable, a little expensive for something that just snaps together if you ask me…READ MORE
One Star
Camera does not fit correctly.READ MORE
Other than that it’s pretty much as advertised
The two halves don’t fully close together. Four internal posts line up with the four holes in the camera board but the camera lens protrusion does not line up with lens hole in the case. Other than that it’s pretty much as advertised.READ MORE
Does everything it should, which is more than others.
Far better than some of the other cases that I’ve used for the RPi camera. They are all the same design, but this one lines up properly, stays closed, and is priced just about right.READ MORE
AVOID - Makes the camera not be recognized by the Pi
Something about this case makes the camera stop being recognized by the Raspi. I’ve tested this with multiple cameras, they work fine as long as I don’t snap the back on the…
Defective three times in a row
This is the third one of these I’ve bought, and every single one was defective. The other two I had to drill out to fit the camera, this one was so poorly fabricated I had to…
One Star
This will break your Pi Camera. It broke two of mine.
Broke my v2 camera. The misaligned camera hole isn’t …
Broke my v2 camera. The misaligned camera hole isn’t immediately noticeable, but when you try to close the case it crushes the camera element.
it worked fine, so I broke something trying to get the …
These are junk. The Raspberry Pi NoIR camera does not fit the posts on the inside of the enclosure. I ruined two NoIR cameras (read, are not detected by vcgencmd get_camera).
Total waste of money
Never buy this item.Camera doesn’t fit at all. Had to drill for wider hole and it was not aligning to the centre of the hole.Total waste of money!!!
Poor Fit…
comments powered by DisqusDoes not fit without modifications to the case the “Raspberry Pi Camera Module V2”. I needed to cut out the hole and make it larger in diameter so that the camera board…
